Drill Press Videos

Back to help page

These are some quick demo videos to supplement one-on-one support in the wood shop. Please ask when you're not sure of the proper way to use this machine and get help when you need it. Remember to always use eye protection and tie back loose hair and clothing.

Basic Intro to the Drill Press

A basic overview of drilling a simple hole, lifting and lowering the table, using a bottom board, clamping down the work, inserting and removing a drill bit with the chuck and chuck key, turning the drill press on and off, lowering the bit into the work, adjusting the depth stop

Using the Drill Press Vice and Using a Variety of Drill Bits

The Drill Press Vice holds the work securly and allows the option of drilling holes at an angle to your work. Various drill bits you can use are: High-Speed Steel Twist Bits, Speed Bore Bits (also known as Spade Bits), Spur Bits, and Forstner Bits. Drill bits are speed sensitive. My old handout on Drill Bits is available as a pdf and may be of some help. Check what speeds are needed for each type of bit you're using and get some help from the Technician or Class Assistant when changing speeds on the Drill press. Spur Bits and Forstner Bits are able to produce very clean holes but usually require a slower speed.

Using the Drill Press Vice with a Hole Saw

The Hole saw mounts on a mandrel that fits into the Drill Press Chuck. Make sure the two pins on the base of the mandrel are inserted into and are driving the hole saw before mounting on the Drill Press. use a slow speed on the Drill Press and always clamp the work down on a bottom board. Using a wire brush while you are cutting to clean the saw teeth gullets will produce the best results. The Hole Saw produces both a hole in your workpiece as well as a disk with a centre hole (which is 1/4" in diameter).

Using the Drill Press Vice with a Fly-Cutter

The Fly-Cutter is the only power bit we have that cuts a hole (or disk) that is adjustable in size. The Fly-Cutter Beam is adjustable once the locking set screw is loosened with a hexagonal allen key. Always lock the set screw once the desired hole/disk size is set. Use a slow speed on the Drill Press and always clamp the work down on a bottom board. The Fly-Cutter produces either a hole in your workpiece or a disk with a centre hole (which is 1/4" in diameter). Which you get is determined by how the cutter is set: a clean hole is produced with the point away from the centre, a clean disk is produced with the point nearer the centre.

Sweeping-Up!

Always clean-up after yourself. Please!





Back to help page